704-821-1402    PHONE

 

 
DOUBLE CHAMBER E-Z VACUUM COATER
  • DOUBLE CHAMBER E-Z VACUUM COATER
  • DOUBLE CHAMBER E-Z VACUUM COATER INSIDE
  • DOUBLE CHAMBER E-Z VACUUM COATER back side

DOUBLE CHAMBER E-Z VACUUM COATER

CODE: 1823051

$21,557.00

EZ COATER DOUBLE VACUUM COATING SYSTEM

The e-z coater is capable of applying a wide variety of coatings to linear moldings or parts and when operated properly can deliver transfer efficiency as high as 100%. Material to be coated is automatically fed though machine. As part enters the application chamber, the coating is pumped onto the part from a recirculating sump system. The part then enters and exits the vacuum chamber through plastic templates that match the profile of the part. Inside the vacuum chamber, high volume, negative airflow spreads and removes excess coating. The removed coating is then recovered and returned to the external sump. It is then filtered and recirculated. When the part leaves the outbound template, the coating is deposited on the part at desired thickness. Deposit thickness is controlled by coating viscosity, feed speed, and airflow. Vacuumed air passes through a series of baffle columns and then passes through a series of fiberglass media air filters before being exhausted out of the building. Due to this process, there is no over spray or odor emitted into the workplace. Clean-up and changeover time and effort is also reduced because the collection basin slides out from its working position and the vacuum/baffle chamber is removable by quick-clamp device.

 

SPECIFICATIONS:

Electronic variable feed rate 50-200 fpm

Minimum workpiece length 24"

Maximum workpiece width 12"

Maximum workpiece thickness 2"

Air filter arrestance rating 75%

(particle size 10 to .3 microns)

Approximate overall dimensions 8' x 3.5' x 5' (LxWxH)

High efficiency filtration system with 15 hp regenerative blower for vacuum creation

Stainless steel construction in vacuum chamber, and stainless steel, aluminum, brass, and plastic (non-corrosive materials) used for construction of coating contacted areas throughout the machine.

Equipped for application of water based, or UV stains and paints on 4 sides of wood parts up to 12" in width

Integrated feed through system with 1 hp motor

Special application chamber and sump design causes little fluid agitation or foaming, and does not drown the part in fluid

Three phase, 460 volt

 

EZ COATER
Cleaned and Tested
Midwest
460v, 60cy, 3ph
Storage

Dimensions

(?)
LxWxH 96 x 41 x 60 Inches

For additional information, leasing or freight quote: (?)

Paul Rhoades
paul@machineking.com
(704) 745-7874
704-821-1402    PHONE

Type the characters you see in the picture below.

None
Loading...